Vehicle & Technical > Defender

200 into n/a defender

(1/3) > >>

gnasha:
i found a lot of write ups were its a 200 into a td but as yet none for a n/a is there a diff or is it the same ie use n/a gearbox then just plumb it all in got my disco for the engine and what ever i need of it just wondering what else i need to get

craig_midz:
exactly the same u need the flywheel housing an engine mounts off the na to put on disco engine and then same old with exhuast but all wiring is the same oh an i used the fuel filter housing off disco as n/a fuel pipes screwed straight in2 it

gnasha:
thanks what about the oil cooler pipes as n/a dont have them also i thinking of using the power steering of the disco as i think its just a bolt off bolt on job for that unless someone says diff

craig_midz:
what i did was get the disco oil cooler pipes lengthened by a mate who works for pirtek an u can use disco pas box an pipework u just have to get pipes lengthened again an if u using disco rad u have 2 lower the rad mounts 2

Disco-andy:
Am i right in thinking you will need to change the drop arm to use the disco pas box?

Navigation

[0] Message Index

[#] Next page