Vehicle & Technical > Defender

disco 300 into a n/a defender

(1/2) > >>

Bish:
I've stuck a 300tdi engine into a N/A defender and have heard you can throw away the 300 loom and wire it in without the ECU
anyone know anything about this?

barmiebrumie:
Was the 300tdi edc ?, if so you will need to put a non edc injection pump on, just done this to a Disco  :roll:

Bish:
its the pump with 3 wires going to the solenoid?

redhand:

--- Quote from: Bish on July 19, 2009, 11:10:39 ---its the pump with 3 wires going to the solenoid?

--- End quote ---

300TDI never had an ECU. it was almost the samer engine as the 200tdi with a few emission controls added.

barmiebrumie:

--- Quote from: redhand on July 20, 2009, 17:43:23 ---
--- Quote from: Bish on July 19, 2009, 11:10:39 ---its the pump with 3 wires going to the solenoid?

--- End quote ---

300TDI never had an ECU. it was almost the samer engine as the 200tdi with a few emission controls added.

--- End quote ---

Later type Disco's have if they have electronic diesel control (EDC) has an ecu tucked up in the driver footwell/A post, if it has 3 wires its for the immobiliser & possibly another 3 for the ERG

I have done this in one of my disco's it had EDC (with ecu) the engine I fitted in had the 3 wire pump, top wires are for the ERG & these can be ignored but the 3 on the back are the problem if they are there you may have to smash the immobiliser off,


Hope that helps


John

Navigation

[0] Message Index

[#] Next page