Vehicle & Technical > Discovery

Wading breather pipes

(1/3) > >>

diff-breaker:
Just wanting bit of adivce from anyone that has fitted axle breathers to Discovery 1 on where best they have routed them ? :roll:

boss:
cable tie them to radius arms and a frame then route them alond the chassis and take them to the top of your snorkle

J.D.:
As Boss says, and on the back, leave the cable ties a little bit slack, or remember to leave some slack in the breather to allow for articulation and do it along the top of the radius arm, otherwise they get ripped off.

stretchy:

on the front its simple just folow where the old breather went but just a bit higher  the rear I zip tied it to the brake line thats just near the sill then folowed the same route as the transfer box and gear box up into the bulk head. you can then take the 4 pipes up the side of your snorkle but what I did was get 3 Tee shaped fittings and made it all into 1 pipe its a bit more manageable that way when you run it up your snorkle

diff-breaker:
Thanks all for the tips - what about the back axle ones ?

Navigation

[0] Message Index

[#] Next page