Vehicle & Technical > Defender

Bonnet Cable Thingy

<< < (2/2)

hobbit:
If you are not bothered so much with the security side of bonnet release from within the vehicle, you could always fit external clamps/pin kits

Vam:

--- Quote from: "Hobbit874" ---If you are not bothered so much with the security side of bonnet release from within the vehicle, you could always fit external clamps/pin kits
--- End quote ---


Or like mine pull the cable by putting your hand through the grill...

Handle came off 2 weeeks after I had her, (I didint do either! :wink: )

MTyrrell:

--- Quote from: "Paul" ---Get a large electricl connector block and cut one section off and use that. :wink:

HTH
--- End quote ---


Cheers paul, ill give it a try tomorrow.

Like the idea with the nut and bolt ill have a go at drilling a bolt on the pillar drill at work, bit too fiddly to do with a hand drill.

Daz, had a look at halfords and the bike cables are all crimped on now, will nip up to the bike shop by me and have a look.

Helen, same here, have been putting my hand through the grill to open it but whilst I have her in bits thought I’d fix it.

Thanks for all the advice everyone. :D
Matt

Vam:

--- Quote from: "MTyrrell" ---
Helen, same here, have been putting my hand through the grill to open it but whilst I have her in bits thought I’d fix it.

--- End quote ---


Oh you perfectionist !!!  :wink:

Navigation

[0] Message Index

[*] Previous page