Vehicle & Technical > Suzuki

need a spot of advice

<< < (2/2)

generation-x:

--- Quote from: tommy tipper on May 18, 2009, 21:28:25 ---
--- Quote from: generation-x on May 18, 2009, 19:44:57 ---tbh without lookin its hard to say when you say its wobbly can you lift it up quite a lot?

simon

--- End quote ---

well not really but does a bit, its a shame you dont live local as you seam the man to have a look at it

--- End quote ---

 :oops: lol

as said above take the rubber cover off and have a look and take some pix


im assuming it wont engage 4x4 mode even if you hold it in place?

simon

horsethief:
Just done clutch change on my vit,£75 for clutch recon from car shop.you need high lift jack,had mine on ramps and axle stands.not to too hard a job.2wd-4wd lever locks in place with a push down and quarter tun clockwise,with a coller on base of lever.Probley just come out.Take boot off and have a look,also be careful putting it back to get it in right place,I had three atempts,then when everything moved that was it.Haynes manual covers the job quite well.If you got garage and help should take about half day.Mine took two month outside over winter with no help :(

tommy tipper:
had a bit of a look tonight, i took the rubber boot off and undid the 6 screws holding the metal plate on and it seemed to be still in place going in to a box but really wobblly and was like it was out of place? if i put it in to neutral would i be able to put it back in place bye turning it like you say??, think i might have to buy a Haynes manual to read a bit about it a bit more my friend said he wil do my clutch so thats no problem its just this bloody 4x4 2 wheel drive problem

winchman:
If you log on to the forum on
www.difflock.com
ask in the suzuki section as no doubt some one will live nearby and have a look for you

horsethief:
The lever may have snapped,no prob really as long as you find the broken end.you'll get one from a scrappy.This lever and the main stick has to come out for the clutch change.the baynot fitting is just push down,quarter turn anti-clockwise on both.you will get a lot of oil when you pull front shaft.

Navigation

[0] Message Index

[*] Previous page