Vehicle & Technical > Discovery

Discovery 200 TDi 3 door

<< < (3/3)

Disco-Ron:
As abpve, i found it best to remove the wing, disconnect the door check strap, then close the door, unbolt it, then lift the handle while taking the weight of the door, and bobs your aunties husband,,......

Scotsman:
yeah taking the wing off would be a good idea. i got a small hole on the inner wing to weld so can do both jobs at same time as the wing has to come off for that. then its on to the boot floor.... :cry:. It isnt at all bad considering, i've seen 94/95 models in terrible condition with rot but this seems to be an exception. sills are original and the inner wings have just one small hole and where the inner arch trim clips are is a little rusty round the holes but not at all serious. Typical rear door surround rot though, im sure they modelled that area on a well known brand of cheese :lol:

Navigation

[0] Message Index

[*] Previous page