Vehicle & Technical > Discovery

Brake problem

<< < (2/2)

wizard:

--- Quote ---he rectified it with a new servo
--- End quote ---

I had the same problem with my disco late last year, i bet he only gets a few miles and the brakes clamp on tighter than a tight thing going tight.....

On the old servo there is a 10mm spacer that sits between the bulkhead and the servo, the new one wouldnt have this fitted.
Hopefully he hasnt thrown the old servo out.
Bung the spacer back in and i bet you a few beers everything will be hunky dory.

wizard

Henry Webster:
Good one Wizard, that sounds like a good candidate!

Disco_Stu:
I'll bet it is too. Nice one wizard, I'll now go back to him and sound like an expert :)

Disco_Stu:
Hmm, he fitted the spacer and its non-ABS.

I agree about the Britpart stuff by the way, I wont use it on my truck. He's gone this morning to get a bearmach master cylinder, I'll go round later and pop his pistons out and see what kind of condition they're in.

Thanks again all.

Stu.

Disco_Stu:
Thanks for the help lads. It was the master cylinder. Fitted the new one, bled up and problem gone.

Stu.

Navigation

[0] Message Index

[*] Previous page