Vehicle & Technical > Discovery

discovery 200 tdi transferbox bearing

(1/2) > >>

travis:
hi can anybody help me out with tecky stuff, i have a 200tdi discovery and the transfer box is winding like a good one and has play if you grad hold of prop and move it up / down, its on the front propshaft side of transfer box. can the bearing be replaced in vehicle or does the transfer box need to taken out / replaced.

JIMBOBLY:
it does have to come out mate,as the bearing is pressed in from inside the casing :(

travis:
thanks, i do have a chance of replacing transfer box from a donor discovery 1 v8 into my discovery 1 200tdi same year, whats the best option. take both out complete gearbox/ transfer box and swap over parts, or just take out  transferboxs  in vehicles and swap.

bilge rat:
id just do the transfer boxes . the lower bolt on the front side when you take that out it will let all the oil out . so either drain it or stick a stud in it on removal . i made some dowels to help refit it . can be a little awkward without catching the front seal on the transfer box .. alan

denviks:
if its the front bearing on the transfer box then i did mine in situ. i have some pics somewhere. it was a case of dropping the front prop, removing the flange . pulling the seal out ....remove the circlip and pull out the bearing. the bearing was a little tricky to pull out.....but will come out.

mine went quite after that  :D

Navigation

[0] Message Index

[#] Next page