Vehicle & Technical > Discovery

200tdi overheating

<< < (2/2)

ben-dent:

--- Quote from: Chris C on March 14, 2009, 22:58:00 ---
--- Quote from: robdog on March 14, 2009, 20:38:33 ---Have you opened the cooling system bleed screws to check that you dont have an air lock that might be building up at high revs.

Rob

--- End quote ---

I didn't know there was any bleed screws for the cooling system :shock: :shock: :oops: where are they?????????

--- End quote ---

chris do you want me to come have a look, there is one on the radiator and thats it on your truck, give us a shout if you need a hand with it

stretchy:

alrite chap check your water pump is ok. under the puly on the water pump thers a small hole that the water will slowly drip out of if the seal/bearing  has worn and also the water will be a rusty couler greatly reducing the rate it removes heat from your block. worth a check.
good luck

Chris C:

--- Quote from: stretchy on March 15, 2009, 13:48:24 ---
alrite chap check your water pump is ok. under the puly on the water pump thers a small hole that the water will slowly drip out of if the seal/bearing  has worn and also the water will be a rusty couler greatly reducing the rate it removes heat from your block. worth a check.
good luck

--- End quote ---

Cheers Ben i'll give you a shout!!! I the engine in 10t of crud today at Cranford so I shoud see any leaks when the mud dries  :lol: :lol: :lol: :lol: :lol:

I think it may also be the Viscous free spinning. I have one thats still attached to my old pump so i'll give that a go!!!

Navigation

[0] Message Index

[*] Previous page