Vehicle & Technical > Discovery

Bottom Pulley on a 200TDi

(1/2) > >>

J.D.:
I need to get the bottom pulley off ym 200TDi engine to rebuild it and it is refusing to budge. So far  have:

bent two pullers,
nearly cracked the timing belt cover,
give it the good news with large hammers,

and it still refuses to budge. Its the first one I have ever not had come off, I know it is welded on or anything as I was the last one to put it on.

Any ideas greatly appreciated.

wizard:
Hi
Do you have access to a gas axe.
Dont chop it off just warm the pully up a bit. Dont overdo it and heat up the crank though.
Do this with a set of pullers in place.

wizard  :twisted:

Saffy:
use the proper puller?

J.D.:
Cheers for the advice guys. The story so far is in the thread in this section called the Birth of Pheonix. Still haven't got the damn the off!

eugene:
i had one like that i took bolt out started her up and moved steering left to right it made it lose by its self but thats nat the best way but it worked that is if engine is still in the truck  :D

Navigation

[0] Message Index

[#] Next page