Vehicle & Technical > Freelander
Mods & Airbags
Rockin Robin:
--- Quote from: KTM Gordo on March 03, 2009, 13:43:57 ---
As for the exhaust guard, I seem to lose out here because I have a tow-bar and they don't seem to allow for them :?
--- End quote ---
The Mantec exhaust guard can be fitted to a standard towbar with some minor modification. T8BUB on the FLC website did it.
Personally never bothered with the exhaust guard as standard box is extremely tough and, if the worst came to the worst, would be cheaper to replace than the cost of a Mantec guard. The guard also reduces ground clearance! Are you running a Diesel? If so, then why not just junk the rear box altogether and run a pipe straight out the side of the bumper :D
Gordo:
--- Quote from: Rockin Robin on March 03, 2009, 22:13:27 ---
The Mantec exhaust guard can be fitted to a standard towbar with some minor modification. T8BUB on the FLC website did it.
Personally never bothered with the exhaust guard as standard box is extremely tough and, if the worst came to the worst, would be cheaper to replace than the cost of a Mantec guard. The guard also reduces ground clearance! Are you running a Diesel? If so, then why not just junk the rear box altogether and run a pipe straight out the side of the bumper :D
--- End quote ---
I know about the ground-clearance issue, but a lift is also part of the plan so it won't be too much of an issue.
It is a diseasel, so that's another option - thank you :)
Doobreydog:
Hi George PM sent poss interested in the roofrack & spoiler...Cheers
trecfive:
--- Quote from: G30RGE on March 03, 2009, 12:35:55 ---Yes - it fits pre-facelift
found picture
--- End quote ---
The mounting plate was made by Mantec
G30RGE:
interesting.. I wasn't aware Mantec made the front mount, I know they made the rear one
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version