Vehicle & Technical > Discovery

200tdi clutch change

<< < (2/2)

bilge rat:
do mine by dropping the box back , dont even take the crossmember off the box just release from the chassis and drop rear end down enough to clear the h/brake drum .then slide back enough . it is tight but you can do it. iff you take the ctr console out to take the lever out and to disconnect the breather pipes and wires use that hole in the trans tunnel, block of hefty wood and ratchet strap . same sort of procedure as already mentioned . i did actually drop one once and had a heck of a job to get clear of it .. alan...

TDi.Si:
Did mine with a turfor and some rope throught the sunroof! Was hung off a pretty substantual steel bar. Had a hand to slid the box back into place though.

Navigation

[0] Message Index

[*] Previous page