Chat & Social > The Bar - General Chat

Superwinch service guide

(1/2) > >>

diggerdog36:
Where can I get one, Im after servicing my EPi9.5 but want a guide on how to do it, I need to replace the solenoids too!
Im after a haynes style step by step guide to removing the motor/brake/gearbox etc.

Cheers peeps

paul_humphreys:
The last time I wanted one for a Superwinch, I sent them an email asking and they emailed one back. But it was for an X9.

Paul

diggerdog36:
 :shock:
OK, Ill give that a shot!

Cheers boss

V8MoneyPit:
It's dead easy. The only bit that you might consider not dismantling is the brake assembly on the end. Leave the circlips in place. It's the only part that needs 'setting up' afterwards, but even then, it's just a matter of preloading the spring by half a turn or so.

I've recently stripped and rebuilt my EP9. I replaced the drum bearings because they were shot. I also took the opportunity to seal the joints as I reasembled it.

diggerdog36:
Stumped at the first hurdle, how do I get the bridge cover off???  I took out the 4x 4mm Allen head bolts on the sides, but the thing wont come off, I cant see anything else holding it on.
Its an EPi9.5 by the way!!

Navigation

[0] Message Index

[#] Next page