Vehicle & Technical > Defender

Doors not aligning

<< < (2/2)

Highland_Defender:

--- Quote from: trickydicky on February 23, 2009, 17:17:50 ---i had a similar problem when i re chassied mine . i found that there is adjusting bolts between the bulkhead and the windscreen the more you tighten them the farther forward it pulls the top of the bulkhead . do you have the hinged type of windscreen hinges? 

--- End quote ---
Yes Ive got a hinged windscreen, where about are these bolts exactly?

I swapped my drivers door again to another i had  and it fits but not perfectly still low, and only just clearing my sliders.
its defiantly my bulkhead.

trickydicky:
the bolts are eather side of the windscreen on the bottom as you tighten them the doorsdack corner should start to lift up . its a dead easy job it will only take about 5 mins 8-[

trickydicky:
also try jacking up the back of the doors when ya do it or you have to give them some welly

Navigation

[0] Message Index

[*] Previous page