Vehicle & Technical > Defender

td5 half shafts

(1/2) > >>

kevinf:

hi there just serviced the rear wheel bearing on my td5 110 and found the half shaft splines quite badly worn!

its got the rover diff as opposed to the Salisbury unit of earlier 110 and have found that paddocks don't sell  them

any ideas where i can get them from  apart from the main dealers 

btw  i am not after any extreme kit unless its cheaper than original kit



cheers kevin

Hightower:
I'm not sure if they are the same, but I have a set of Disco Td5 half shafts sat in the garage.

Let me know if they are of any use to you.

kevinf:
thanks for offer hightower  i will try and find out if they will fit and get back to you



cheers kevin

BS3143:
Kevinf

            The defender 110 rear diff was changed from the Salisbury type to the P38 type (Nothing to do with Range Rovers). This i believe was around 2002 model year. I recall being told that the half shafts are many times more expensive then the Salisbury ones and it may well be a trip to the main dealer. Maybe some aftermarket company may well now be selling something as these vehicle get older and wear. Hope it dosn't cost you the earth.......
             
            Ian.

SteveG:

--- Quote from: BS3143 on February 22, 2009, 00:20:27 ---Kevinf

            The defender 110 rear diff was changed from the Salisbury type to the P38 type (Nothing to do with Range Rovers).

--- End quote ---
apart from it being the same 4 pin diff centre used in the rear of P38A RR's  ;) ;)

Navigation

[0] Message Index

[#] Next page