Vehicle & Technical > Discovery
Peeling Dash Syndrome
RichardM:
--- Quote from: SteveGoodz on February 22, 2009, 11:26:02 ---....see if I can't fit it in a couple of weeks when I've got some time off work.
--- End quote ---
I know we said it's a pain Steve, but it'll only take a couple of hours, not a couple of weeks... :lol:
SteveGoodz:
--- Quote from: RichardM on February 22, 2009, 17:18:37 ---
--- Quote from: SteveGoodz on February 22, 2009, 11:26:02 ---....see if I can't fit it in a couple of weeks when I've got some time off work.
--- End quote ---
I know we said it's a pain Steve, but it'll only take a couple of hours, not a couple of weeks... :lol:
--- End quote ---
Listen, the way things are going at the moment I wouldn't be surprised if the bulkhead didn't peel up when I bolt this down :twisted:
bilge rat:
did mine too looks good , had to fettle the dash binnacle a little to fit , think i got some better quality screws to do the job , and as said cant be done without a 90 deg screwdriver , or a 1/4 drive ractchet and s/driver atachment . bit tight though. alan..
BigA:
could always try a ratchet spanner and screwdriver bit, if you can get the screw to start, i think i have an adapter somewhere that fits in one of the spanners?
As has been said, it is a pain, but worth it, pretty much standard Landy ownership ;)
craig_midz:
ive just done the heater matrix an changed the dash in mine an to be honest it wasnt as bad as i thought it would be me an mate mate did it in a couple of hours at a leisurable pace i was quite suprised how easy it came out an went back together
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version