Vehicle & Technical > Range Rover

P38 rear seat help

(1/2) > >>

ben-dent:
My dads Rangie P38 failed on a rear seat belt Catch not working, it is the one in the middle of the larger side (drivers side)

how do you get to the bolt that holds the seatbelt catch on, i have a new clip (from a rover 400 - it is identical except the clip needs to trim the end of the buckle as it has a bit on it)

Cheers in advance

waveydavey:
Don't you just tip up the small bit and find it there? Possibly have to take off the plastic cover first

ben-dent:

--- Quote from: waveydavey on February 05, 2009, 16:18:39 ---Don't you just tip up the small bit and find it there? Possibly have to take off the plastic cover first

--- End quote ---

nope i tried that, i folded it up, and there is a steel plate with a few screws in it, i took all the screws out but that only released the seat catch not the seatbelt buckle,

it is bolted in to the seat base some how??

waveydavey:
For the MOT just prise the plastic off and fix it - the last one I did had a sweety wrapper tucked into it (aren't children wonderful?).

If you are careful you can stick it back together and if its a mess at least you have time to play to change it

waveydavey:
looking in the manual it is there but you have to take the seat out first

Navigation

[0] Message Index

[#] Next page