Vehicle & Technical > Discovery

one shot

(1/2) > >>

henryandlesley:
how much do i put in and how many pots would i need i am doing the swivels once all the welding is done as i have to change one ball due to been pitted and the seal is leaking and the other side is leaking aswell or can i put half grease and half ep90

eugene:
hi mate not sure but i think its one sachet per side but could be wrong :D

wizard:
Yep one pack per side (like the name suggests) :roll:

Run the packs under hot water for a while to make the grease all sloppy, that will make pouring it into the tiny filling hole easier.

wizard :twisted:

ben-dent:

--- Quote from: muddy henry on January 23, 2009, 19:13:17 ---how much do i put in and how many pots would i need i am doing the swivels once all the welding is done as i have to change one ball due to been pitted and the seal is leaking and the other side is leaking aswell or can i put half grease and half ep90

--- End quote ---

as every one say it is one pack per side, and definatly do not mix EP90 with the one shot, as that will make it leak if the seals are gone

bilge rat:
iff you can get a big size syringe and fill it from the bottom up , like on outboard motor gearbox's . goes in a treat .. alan..

Navigation

[0] Message Index

[#] Next page