Vehicle & Technical > Range Rover

Torque Settings

(1/4) > >>

Yoshi:
I will need to take one of the heads off the v8 over the weekend, but will need to know the torque settings to tighten it back down when refitting!

Cheers

Dan

craig_midz:
if i remember rightly its 30 nm an then its 60 degs an then another 60 degs

Yoshi:
Ok, first bit i get cos i have a torque wrench, dont understand the rest though! lol

waveydavey:
It means that you torque them down to the setting then go round again in sequence turning each one extra flat (60 degrees) and once that is done you do exactly the same again for another flat.

IE a total torque of 30nm plus turn them by an extra 1/3 of a turn but not all at the same time

Yoshi:
right ok!  Think i have got that now! lol

Navigation

[0] Message Index

[#] Next page