Vehicle & Technical > Discovery
i think i have the most rotten 1997 disco arround
KingWolf:
Your not having a lot of luck with your Disco mate are you mate...!!!!
Hope you get it sorted soon Henry - if you need a hand with anything just give us a shout.
Mark
KingWolf:
Never tried it - but I make a wicked cup of tea...lol
mark.
300TDi Disco:
From my little experience i have learnt about disco's, i would say check the sills, rear arches, Seat belt points (rear), boot floor. etc> They seem to be abit of a nightmare but once the work is done and done properly it should last you another 10 years.. good luck mate. you will find more and more the further you go through it.
eugene:
well what can i say mate the m reg ive got at the yard was as bad as that and that was worked hard at least youve made a start on it them sheets of metal from hrg a good for doing sills and rear cross member i never used underseal i put loads of coats of hammerrite on mine when i done sills boot floor and rear crossmember 2 years ago and still shiny and strong and no show of rust and leave then plastic sill covers of they trap wet and crap between them and the sill good work so far will she be ready for sunday i now you want me to pull you out of the mud again ha ha :D
digger:
are you sure the body will stay attached to the chassis going round three holes sunday henry looks good what you have done so far mate i dont envy you welding the sills up theres nothing worse than getting a hot spot dropping in your ear when you are welding away i dont no how many times i have set myself on fire when welding under cars good luck with it hope it all goes well
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version