Vehicle & Technical > Discovery

R380 into 200tdi

(1/2) > >>

Bobtail:
What do i need to do to fit the R380 to a 200tdi disco

Is it a straight swap?

any help greatly appreciated

cheers

Jim

wizard:
Hi
When i did mine all i needed was the R380's handbrake cable and the speedo drive from the lt77 box on the 200.
I think i also used the R380,s crossmember. I was a few years back and my memory fades after a few days......

Regards
wizard :twisted:

J.D.:
Yep, the handbrake cable on an LT77 is rod actuated on the box, whereas the R380 is cable actuated all the way into the box, so you will need the R380 cable. The crossmember will fit, but it is easier to use the R380 crossmember.

The speedo drive either needs to be swapped for the LT77 one, or use an R380 speedo cable. Either way will work.

Range Rover Blues:
R380 won't have a speedo cable it will have a speed transducer on the gearbox.  Later LT77s had a short cable to a speed transducer on the chassis.

I don't know whether you can attach a cable to the R380 box that easily but I presume others have found it easy.

Does anyone else think the later handbrakemechanism is poo? the one on our TDi is rubbish despite having a brad new cable on it and a good old strip down it's not a patch on the cable and rod handbrake on Blue :doh:

Anyhoo, on the LT230 T-Box you should be able to mix 'n' match handbrakes.

Can't comment on the crossmember but if you can't find one locally and you need it give me a shout.

squaddie_fox:
u can take out the speed transducer an bolt speedo straight to it an cross member should bolt up in same holes as old cross member an u right rrb hand brake on 300's are crap compaired to the rangie

Navigation

[0] Message Index

[#] Next page