Vehicle & Technical > Discovery
coulpe of questions
discotec:
gotta do mine yet too as mine have folded nicely at the rear too
Like i lol.... :clap: :clap: :clap: :clap: :clap:
only us land rover owners...
JIMBOBLY:
the best tool i find for cutting arches,i done my rangie with a 2 inch angled disc cutter,but mate,be careful,or you could go across ya paintwork,not that ive done that,hut hum :oops:
discotec:
angle grinder..paintwork...no worried about that as i am re painting her sandstone by roller brush....and then some nice decals
Range Rover Blues:
I agree on the pressures, stick to standard 26/34.
As for the "camel cut" or as we RRC owners say "standard ;)" try removing the bolt secruing the body side to the mud flap bracket and extending the bracket to push the bodywork out an inch. Then all you need do is fold the bottom edge of the wing upwards for about 2-3 inches to clear the tyre.
beggers:
Did you have to do anything else when fitting 235/85 tires cause I was gonna fit em and Siminites said it needed a 2" lift so I've held back. Does the front need anything doin. Mine is used mainly on the road but I do go off road when I go shootin but nothin too bad.
Thanks
Andy
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version