Vehicle & Technical > Discovery

clutch slave cylinder

<< < (2/2)

meader:
therr is no harm in asking the garage but we all no wot they are like wwen something comes back . if they wont do it you will have to get some eze outs and drill it out

robert francis:
he bought the disco 6 months ago and the sales garage done the clutch on warrenty, so i said to him go see the as its worth a try

Range Rover Blues:
If the clip holding the clutch cylinder push rod is not there or has come adrift then striclty speaking it's a gearbox out job, without it you can't assemble the cylinder to the bellhousing.

As for warranty, I'd have advised you went straight back before laying a spanner on it, not they will argue you did the damage.  5 months is acceptable as you would expect it to last way longer, but you may need a small claims court to decide in your favour.

There is a bodge if it's just the slave cylinder.  Cut a hole in the bellhousing with a holesaw to allow you to get inside and refit the clip, then mastic the slug of ali from inside the holseaw back into place, or cut a plate to cover it and again seal with mastic.

Navigation

[0] Message Index

[*] Previous page