Vehicle & Technical > Discovery
Disco intercooler upgrade
trecfive:
I'm just a bit worried how long it will take to dry after a proper clean at this time of year! :lol:
[/quote]
It will take you 30 seconds to dry the intercooler out, assemble it all together again except for the top hose connection, on the inlet manifold, place a large rag over the exposed pipe, and run the engine up too about 3000rpm for a few seconds, (catching wot comes out of the pipe ,if anything in the rag) stop engine and refit the pipe. Job done.
Sharpshooter:
--- Quote from: TEMPER593 on December 16, 2008, 02:07:19 ---I think im going to get in touch with the makers of the RS cooler and Allisport and get some facts and figures and see what i get.
If one's cheaper than the other and they do the same job then im up for a spot of DIY!!!
Who else makes intercoolers for discos? :-k
--- End quote ---
Alot of it will depend on how good your engine is anyway.
TEMPER593:
Well the one im hopefully getting on saturday should be a goodun so i'll wait and see.
Soon as its fitted its all goin to get tuned up ant tweaked so i'll see what resault i get. :D
TEMPER593:
Anybody know what sort of figures i should be getting from a tune up and a front mounted intercooler?
Cheers TEMP
Sharpshooter:
The one i have (Alisport Full width) Quotes up to 35% increase. Which i fully believe. And for the one that is the same physical size, but twice the thickness they quote up to 20%. Standard the 200 and 300Tdi are about 111bhp and 280nm of torque.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version