Vehicle & Technical > Isuzu / Frontera
clutch.
dxmedia:
--- Quote from: 666 on February 16, 2009, 22:45:58 ---
--- Quote from: dxmedia on February 16, 2009, 22:17:14 ---Oh I'm a 10 stone puny guy and I've done it that way.
--- End quote ---
And thats wet through :lol: :lol: :lol: :lol: :lol: :lol:
Sorry Chris, couldnt resist :oops: :oops:
--- End quote ---
Can still bench press a gearbox though Mark ;)
Wish I still had one of my old YMT flywheels, one of them would make you wince :lol: :lol:
intercooled GnT:
i did it :) use the hand chain crain thingy.. took 6 bloody hours to get it lined up. itso on the shaft butgot about half inch more to push faward to start bolting on down..
be glad to get this job over with!! lol
ChrisW70:
--- Quote from: 666 on January 29, 2009, 07:27:00 ---Thats where the fun and the bad language starts :rolleyes: :rolleyes: :rolleyes:
--- End quote ---
Think that was the first post wasn't it?
666:
--- Quote from: intercooled GnT on February 18, 2009, 12:09:57 ---i did it :) use the hand chain crain thingy.. took 6 bloody hours to get it lined up. itso on the shaft butgot about half inch more to push faward to start bolting on down..
be glad to get this job over with!! lol
--- End quote ---
Nice one! Much easier when its supported from above aint it ;)
Glad you finally got it sorted :cool: :cool: :cool:
intercooled GnT:
:D :D :D i got it all finshed and back on the road today!! went to gether sooo easily.. not one swear word come out my mouth which is a rearity lol
cheers for the help guys..
sooo isuzu trooper, f-reg 2.8td swb for sale :P
new clutch, bfg a/t. good tred.. drive well? offers lol
cheers then!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version