Vehicle & Technical > Discovery
How do i bleed this?
DiscoDan:
Hi.
Try your local genuine parts store. For small parts like the pipe and bleed nipple they are reasonably priced.
If the threads are ok in the slave cylinder then by fitting 2 new parts you know you have the right parts in the right place.
Cheers, Dan
andyb:
--- Quote from: J B on December 08, 2008, 18:18:51 ---a gentle bend downwards should sort it
--- End quote ---
True, but could also crack the pipe.
It looks too short to me. I know, probably came out of the factory like that, but no reason not to 'improve' the breed :)
ChrisW70:
Difficult to tell looking at the photo ref thread sizes but it's not a case of someone has screwed the bleed nipple into the wrong hole is it?
dan3411:
i could swith them over.. but then that would mean that the bleed nipple is on the top. and wouldn;t be able to get all the air out of the system.
Disco-Ron:
--- Quote from: dan3411 on December 09, 2008, 15:50:13 ---i could swith them over.. but then that would mean that the bleed nipple is on the top. and wouldn;t be able to get all the air out of the system.
--- End quote ---
Sorry to say this, but the bleed nipple is SUPPOSED to be at the top...!!! air rises, simple as that!!!! you'll never get all the air out of it if the nipple is not at the top...!!!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version