Vehicle & Technical > Discovery

Cam Belt change- Disco 1

<< < (2/2)

90Mike:
Hi mate i have just done mine after it the belt broke on my 300tdi  :doh: It's not a bad job with everything out of the way BUT i did have fun and games getting the bottem pully off  :evil:


--- Quote from: andyslandys on December 03, 2008, 20:49:44 ---i would suggest changing belt and tensioner and idler pulleys aswell while you are there, you will need a front cover gasket and seal, there is a 4x4 specialist in wolston, definitely worth a call can be found on yell.com. relatively straight forward to do just take your time and make sure eerything is locked and marked up upon strip down and put back together exactly.

--- End quote ---

Would highly recommend these guys they are very friendly and very helpful ask to speak to andy or greg in parts they will look after you  ;)  ;)

Les Henson:
This thread is the replacement of the timing belt on a 200TDi Defender, which is the same as a Disco with the exception that a Disco engine has an idler wheel, whereas the Defender doesn't.
You should at least replace the belt, tensioner, timing cover gasket, timing cover dust seal, and water pump gasket.
If there's evidence of engine oil inside the timing case, then crank front seal and/or camshaft seal.
I wouldn't use cheap kits - they tend to contain poor quality parts.

http://forums.lr4x4.com/index.php?showtopic=14285


Les.

JIMBOBLY:
how you doing mate,when you do the cambelt,like the others have said changed tensioner and everything,and dont use cheap belts mate,use dayco,which is what genuine is,and i always go through the tappet gaps as well,you will notice a difference,and be carefull prizing the timing cover off,they dont usually give problems,but a mate has broken one before now :D

Porny:
A 200Tdi Cambelt isn't hard to do.... (well in saying that  the Land Rover 'specialist' that did one my customers cars last couldn't do it lol)

I do a complete cambelt kit for a Discovery - including a Dayco Belt, OE tensioner and idler, and genuine spec gaskets for £55 + vat.  I know that there are cheaper kits around, but I only use genuine or OE parts - not cheap replacements.

And I'd also change the cam and crank seals (x2).  Although more work (although a lot easier with the belt and pulleys off), if you don't know when it was ever changed, I'd take the front cover at the same time and fit a new paper seal from the water outlet on the block to the front cover (called a P gasket on a 300Tdi, bit on a 200Tdi its more of 0 gasket).

The hardest thing is usually getting the pulleys and damper off.  Without pullers, you will struggle.

Its then just a case of lining up all the marks, locking the flywheel and FIP and putting it all back together.


Ian

Navigation

[0] Message Index

[*] Previous page