Vehicle & Technical > Jeep

No Acceleration

<< < (2/2)

J66P:
Will be stuck in limp mode, most likely to be knock sensor on number one injector but you better get it onto a bosch tester to make sure

The Smiths:
You could also try the fuel filter.

I had this once on mine - would rev OK, but struggled to pull it at all - going up an hill I was down to 10mph :oops:

I was using bio and was expecting to change the fuel filter - but it was on the floor when I flooded the car so was no use :roll:

benbenukuk:
well we took it to a garage and they have found out the problem: some hoses connected to the turbo had collapsed, And they also found a water leak  :( but they are going to fix it all for free  :D as they brought the car from them and they have had nothing but trouble from it cheers,  Ben

Bishops Finger:
Seems a result..let us know if its fixed OK...

offroading.net:
seen quite a few do this, the internal layer of the hose delaminate and block the hose but look fine from the outside

Navigation

[0] Message Index

[*] Previous page