Vehicle & Technical > Discovery

daisy 2.0 build

<< < (6/66) > >>

Jake:
Bring on the cutting tools!!!
 :twisted:

boss:
done some thinking with the help of the calculator.......im going to have to cuth the chassis down at the front by about 2-4 inches and cut the cross member out, the rear i will have to cut off even more! and weld on some straight pieces of box (rather do this than chop the winch trays about) not good:(
cost of things are going up aswell...just seen some of the new breed of russian trucks.....if im going to be competitive in any way over there i will need portals  :sad: more to the list of stuff to buy.....

devon 4x4 want any advertising over seas jake? :lol:

Jake:
This sounds like an expensive build dude!!
 :shock:

Ker-ching
 :D

boss:
hmm....cost is irrelivant if its something you do anyway. it is very much a case of you get as much out of it as you put in.....

think the ker-ching-ing is a bit premature m8 at the moment the only bits that i need from D44 are the trays and the boggers. and maby a winch man if you want to come along ;)

boss:
was chipping away again today. doing more measuring, little of this little of that. re attached a door and the difference that not having anything in there is increadable! its so light on the hinges! black is now the decided colour. been measuring up and considering a trayback but i think it will look too much like chris abels rangerover....i do not want this. so i might just leave it. cleaned out the inlet, had to do it the old fashon way and use rags....i have blisters on my fingers :(
but what ever all worth it in the end.

Navigation

[0] Message Index

[#] Next page

[*] Previous page