Vehicle & Technical > Discovery
daisy 2.0 build
boss:
oh and got whats left of the drum brakes off today. lots of mayonaise on the rear so better breathers are definatly needed! no pics(unless you want camera phone pics :->) given it a going over with a wire brush too. tomororw there will be pics of a hopefully 100% clean axle.
turbonutter:
i would get what tyres u are goin to use , so u can build around them
will give u the hight from axle to floor then from that u can work out the hight the body will sit at , are u going coilover or landy setup ?
boss:
dont get me started :roll:
pressure washer wasnt working so could only get it as clean as the wire brush would let me with out scratching stuff too much.
hammer wins all. but axle beats me as weight to strength ratio isnt in my favor. there fore it is not in line. but this matters not as there is no welding being done at the moment! :D
will get round to that eventually :roll:
Little-Green-Machine:
looking good!
didnt realise how much beefier those axles wer compared to the standard lr units!
I likes that rear bumper would look nice on the back of mine :twisted:
keep it up :clap:
boss:
rear is ugly as sin though. thinking of going 4 wheel steer just to get the rear one looking sort of presentable. but thats lots o work and i cant ne be arsed!
rear bumper is a concoction of D44 parts and lots of trial and errors, can make one for you if you want one on the back of your series.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version