Vehicle & Technical > Discovery
daisy 2.0 build
boss:
its going to be wide :lol: probably going to get wheels with little or a negative offset, so its not going to get too much wider and itll protect the portal boxes. then again nothing is set in stone.
turbonutter:
--- Quote from: boss on June 25, 2009, 20:24:51 ---its going to be wide :lol: probably going to get wheels with little or a negative offset, so its not going to get too much wider and itll protect the portal boxes. then again nothing is set in stone.
--- End quote ---
thats the problem with mogs
iv got very little offset with my rims on the volvos and iv managed to keep it as near to landy width :D
a mate has mog axles on a custom build , the axles where cut down and custom shafts made up
gets the width back down but is mega bucks
boss:
yes, and if a shaft brakes hes in trouble.
big with isnt always a bad thing, it spreads the weight a little more. but i wont be able to fit anywhere :(
nevermind ill drive over it :lol: :twisted:
mikiep1986:
lol thats logicall thinking boss ha ha if in doubt drive over it ha ha . . . wouldnt normal disco steel wheels or alloys work to reduce the offset . .
boss:
they would work yes, but i need stronger wheels than that, with beadlocks. and the mog has 6 studs with a different pcd......may be sorting that out soon though.
either going to go to stazworks or somewhere like BTF, mach5 have a website? i know there is such a thing as a mach6....but the only ones i have seen are 20" and look gay.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version