Vehicle & Technical > Discovery
daisy 2.0 build
boss:
yes, that will work.
i personally dont like the look of disco tray backs. it works with defenders and to a certan extent RRCs but discos are curvy and the curvyness needs to be kept in there to make it look right. i was thinking along the lines of what your discribing a trayback wut with body pannels. getting the curve for the wheelarch right with out a radius roller will be HARD and near impossible.
J.D.
is it any good? from the cycle performance of mine i dont think i would buy another sealy.
discorich:
Yeah i had thought of that and was thining of tyring to get a bit of bend on the pipe and then pull the body panel in a bit to match up, kind of meet in the middle ground.
cheers for input Boss.
J.D.:
Boss, I aint used it for a long period of time yet, but it seems to be godo enough for what I need it for. I have access to a 1,000amp, 3 phase welder if I need it, so I don't neet a mahoosive one.
Little-Green-Machine:
Any updates mate? :D
Or are you keeping us in the dark again :lol:
boss:
no updates :( i was ooooooot and aboooot this weekend at bircham.......total waist of my time really! absolutly gutted my disco wasnt there. course was so easy that i got the shogun around on "aggressive" road tyres then at then end of it i realised it wasnt even in low ratio! had to physically kick the leaver over, super select my a*** rear locker did help alot i guess but i still dont like them.
on the plus side.....i get my cast off today! and i get to go see the new terminator film and i get to go back to work :D :dance:
should have an update this weekend, if they still dont let me go back to work(got to do alot of physio apparently :roll:) then youll have one sooner :lol:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version