Chat & Social > The Bar - General Chat

Very low cost dent removal

<< < (3/3)

Bob696:
seen a similar video and the guy uses an inverted compressed air can (for cleaning out computers)

Range Rover Blues:
It does work, well it can work.

It won't work if the panel is stretched, not that well but it will remove those awful "sopmeone walked into my car" dents you get.

I've also seen it done with a hari drier to heat the whoole panel then an aerosol of CO2 propelant (used as a duster for circuit boards) upside down so that the propelant comes out and freezes on the panel.

The hotter the panel the less likely the paint is to craze/crack or chip.

Oh, it won't work on Aluminium/duralumin or Birmabrite though :(

Navigation

[0] Message Index

[*] Previous page