Vehicle & Technical > Range Rover

autobox problem

(1/3) > >>

Oli-L:



 Right just fitted a ZF 4 speed gearbox in my range,  changed the fillter and oil and it dosen't  seem to drive at all!!!  :'(


 PLEASE CAN SOMEONE HELP??????????? :afro:

turbonutter:
sounds like theres a prob with the torque converter
what way did u fit the box , fit the tourqe con to the box and then put the box in or fit the torque con to the flywheel and then out the box in ?

iv had it before when u damage the drive in the torque converter when fitting

Oli-L:
we put the converter in the box first then fitted it, i just swopped the convertor that was out the orgianl gearbox...

craig_midz:
have u got the right amount of oil in box an also when i did 1 i had to go through all the gears a couple of times an silly question but easily done the transfer box hasnt been knocked in2 neutral has it an also check that the pump on the auto box is workin disconnect the pipe to the oil cooler an start car up an put it in gear if oil comes out pump workin if it dont pump aint working so u wont get any gears

Range Rover Blues:
Yeah, what he said.  Part of the service check was to connect a pressure gauge to the oil delivery pipe and there is a connection at the front end of the boc for it, so check you have oil moving about in the box.  Also if you swapped the fileter check it's seated properly with the seal in place.

Navigation

[0] Message Index

[#] Next page