Vehicle & Technical > Discovery
Rear axle/ a frame ball joint removal - HELLLLP!!!
Disco_Stu:
Just in case....
IIRC it's a castellated nut, did you remove the split pin?
Geoff30:
--- Quote from: Disco_Stu on October 28, 2008, 17:09:43 ---Just in case....
IIRC it's a castellated nut, did you remove the split pin?
--- End quote ---
lol yes I have sort of removed it, the ends fell apart same as the nut.
Have decided that I going to remove Aframe and have a new balljoint pressed in. It just so happens I am doing a refurb at a bus garage and they have a press and no bosses in on a Sat :dance:
Geoff30:
OK old axle is off now, new ball joint is installed, so just got to put the lot back together, hope to do it tomorrow, trying to decide if I should do a lift while car is in bits.
Navigation
[0] Message Index
[*] Previous page
Go to full version