Vehicle & Technical > Discovery

temp sensor on head of 300tdi

(1/2) > >>

Andy41:
I need to renew the wires that run to the sensor on the head
without cut open loom i aint sure where they run to
i assume down to the throttle body but sure ??
anyone got any ideas.

Haynes and LR workshop manuals checked and about as clear as mud.

bilge rat:
sensor in the middle of the head ?. aint that something to do with the e.g.r system . sure it is . so iff you have removed that i wouldnt be to worried . but it must go as you say to the throttle position sensor on top of the pump ..alan

Andy41:
thanks for that but not sure it has anything to do with the egr system which is blanked off.
should have said that i replaced the sensor because the connector broke off causing jerky acceleration
and poor running but since its bin renewed its not bin to bad.
i think i will have to trace it at least the wiring loom is already split just to make life a tad easier.

stageonesimmo:
As was pointed out to me a few weeks back - that IS the temp sender for the EGR system - its opening point/duration is based on throttle postition AND engine temp, among others....

So if you have binned the EGR I wouldn't spend too much time/effort on it................

Andy41:
ok thanks for all the replys i think ill just ignore the wiring then.... ;)

Navigation

[0] Message Index

[#] Next page