Vehicle & Technical > Discovery

200 heater motor

(1/2) > >>

bilge rat:
think it must be seized. can i get at it . cant seem to find it . different to the 300. can someone tell me iff i can get at it . alan....

eugene:
i had to take the dash out a pig of a job the heater and fan bolted to the bulkhead had a rat jam in it whikle i was doing it up lots of black smoke a nd a burn rat but i couldnt see any other way of doing it so goodluck anyway :D

bilge rat:
you dont think theres any way of getting any thing on it to try to spin it up . im sure its just seized . been stood abot6 mths. thanks. alan

crazymac:
Chances are it has burnt out :-k

And the only way to get to it is remove the whole bulkhead :'(

Its a lot of work but not difficult in its own right!

Centre console, steering wheel, top binacle then about 8 other fixings if I remember right? then you could do with another person to help you lit it out as its a bit floppy :roll:

wrecker:
i done this a few weeks back mate,

and there is no way to get at it with out gettin the dash out,

first pic is dash out,that black box in the middel,thats where the motor is at



2nd pic is with it out



and this is what you have to split in half to get at the motor,make sure you have a helper here,it makes the job a lot quicker


if you look left bottom,that the wires for the motor,and some of the motor,

hope this is of any help to you :D

Navigation

[0] Message Index

[#] Next page