Chat & Social > The Bar - General Chat

mud club splats

(1/2) > >>

henryandlesley:
hi got my splats but what is the best way to peel the back off as when i try the letters stay on the bacing

diggerdog36:
Obviously you made sure the suface was clean and dry??
Rub the sticker down with your knuckle or thumb, then peel the backing off slowly, but instead of pulling it away from the panel, pull it flat to the panel...hard to explain without pictures, but make the backing do a 180 deg turn, instead of just a 90 deg turn.

TRY HERE

hairyasswelder:
http://customvinyldecalsnstickers.com/graphics_tips.html

May be some help?

Disco Matt:
Not much else to say - just make sure the area is clean (sponge and soapy water, then rinse and allow to dry) and make sure you get all the air bubbles out.

The fun comes when you fit a big vinyl like my Camel Trophy stickers - ended up using soapy water to avoid bubbles, and a steel rule to make sure they were the same distance along the doors on both sides!  :lol:

DoubleTop:
if you get the temp right, a little bit of warmth makes the application of vinyl stickers a lot easier in my experience.  Explaining to SWMBO why her hair dryer is broken, that's the tricky bit.

DT.

Navigation

[0] Message Index

[#] Next page