Vehicle & Technical > Discovery

panhard rod bushes

(1/3) > >>

alex_mh:
i need to replace these for my mot, are they easy to get out and new ones in or do i need to use a press?
thanks

solihull-mick:
If there standard bushes they can be a pig to get out with out a press, you can burn them out, the standard bushes will go in with a good vice, poly bushes will go in fine with a vice,

peasey:
I have done mine recently,i found the best way was to drill out as much of the outer sleve as you dare without channeling out the panhard rod bush hole,i do this by starting with a smallish drill and working up and twisting the drill up and down gentley to cut the outer sleve,and then getting the biggest hammer you own and smashing seven shades of s**t out of it,have a real good argument with the mrs first and the will soon be out :D

Range Rover Blues:
It's one place where polybishes are a really good move.  After 2 years mine were still in good nick, but for £4 each you can swap them as often as you like.

freeagent:
Burn them out and cut the outer sleeve with a hacksaw, you'll need to put 2 or 3 cuts in it... at this point it'll either fall out, or can be knocked out with a screwdriver/hammer...

i'd also replace with good quality polurethane bushes (polybush/bearmach/superpro)

Navigation

[0] Message Index

[#] Next page