Vehicle & Technical > Discovery

clunk bang

<< < (3/3)

mass199:
Got  it!
it's the aframe  joint, got my jimmy bar and gave it a wriggle, lots of movement and a clunk, replacing this will be a good start point.    Is this an easy job, will i need special tools and will it cost much for the parts.

                                thanks any advice appreciated

Disco_Stu:
Special tools:

Rear suspension upper link bolts = 1 3/16" AF socket.
Upper link to ball joint = 19mm sockets both sides and can be vey tough to split.
Rear suspension trailing arm chassis mounts = 1 3/16" AF socket.
Rear suspension trailing arm to axle = 24mm socket.

plus gas or similar, BFH. If it wont come out maybe a grinder/hacksaw etc. Jack and stands obviously.

Navigation

[0] Message Index

[*] Previous page