Vehicle & Technical > Discovery

can it be done ???

<< < (2/2)

Range Rover Blues:
This is the valve spring compressing tool for the pinto engine.  It's not that clear I'm afriad but if you imagine there are 2 blades to it, that hook under the camshaft then each has a crescent shaped pad which bears onto the valve spring seat.  On a Pinto the rockers are secured to a rocker post (which is adjustable) then are located sidewyas on the top of the valve stem also.  For the TDi you'd need to spin the rockers out of the way then refit the rocker shaft I guess.

Range Rover Blues:
Does this make it clearer?

wizard:

--- Quote from: clbarclay on August 07, 2008, 22:06:09 ---
--- Quote from: wizard on August 07, 2008, 21:49:04 ---Can the valve stem seals on a 200 TDi be changed without taking off the head ?
--- End quote ---

Why don't you want to remove the head?

--- End quote ---

I dont have a lot of time to spend on the job really.
I suspect the stem seals are leaking on #1 cylinder so i was just going to change them untill i get a bit of time to do the lot and the head gasket.


wizard :twisted:

Nick4X4:
Yes you can do it
You drop it down to bdc and use compressed air to keep the valves shut
You can buy the tools to do this so you do not have to make them  ;)

mobi:
i have a tool to do ford cvh engines and it just a rocker but with a fork instead, so it pushs the spring and not the valve.

Navigation

[0] Message Index

[*] Previous page