Vehicle & Technical > Discovery
10 or 24
Banjo:
Is there any way of telling which my late 200 has fitted, other than the obvious.
andyb:
Flat rather than mushroomed drive flange ends (hub end :) ) on the halfshaft mean 24 spline.
Disco-Ron:
--- Quote from: andyb on July 29, 2008, 16:13:31 ---Flat rather than mushroomed drive flange ends (hub end :) ) on the halfshaft mean 24 spline.
--- End quote ---
Sorry to disagree Andy, but my 10 spline ones have flat drive flanges....... they changed from domed to flat when they went from imperial to metric......
i'm not aware of any dead sure way to tell, apart from pulling a shaft out, which for the sake of 5 bolts and a gasket is so easy you might aswell do it to be sure!!
andyb:
--- Quote from: Disco-Ron on July 29, 2008, 22:21:17 ---Sorry to disagree Andy, but my 10 spline ones have flat drive flanges....... they changed from domed to flat when they went from imperial to metric......
--- End quote ---
Not at all thats fine :)
However, all flat ends will be 24 spline by that reckoning? :)
Disco-Ron:
--- Quote from: Disco-Ron on July 29, 2008, 22:21:17 ---Sorry to disagree Andy, but my 10 spline ones have flat drive flanges.....
--- End quote ---
So my 10 spline flat ended ones are really 24 spline then...lol..... [-X
Navigation
[0] Message Index
[#] Next page
Go to full version