Vehicle & Technical > Discovery

Disco in dispare

<< < (4/8) > >>

lurch_917:
high fruity you could have the same problem as i had a few months ago the head gasket had gon between the cylinder and a water way so it didnt give me any sluge in the water just kept cooking the collant and preasurising the header tank

Mud-muncher1:
hmmm  :-k, good job i've just ordered a new one along with new rads, pipes etc  :grin:, lets just say they got abit trashed while playing in the mud

bilge rat:
does sound like head gasket , iff you over heated it due to the mud blocking the rad you may have been unlucky enough to blow the head gasket . it was probably on its way out and that was the final push. iff you make up some sort of tool to fit a glow plug set it to firing stroke on that cylinder , lock the engine and pressurise that cylinder. take the cap off the expansion bottle fill to top and iff you see loads of bubbles you will know which cylinder has gone. only sure way withought stripping unless you know a friendly garage with a block test kit . like a sniff test . but that will confirm the h/gasket gone but notr on which cylinder . hope this helps ..alan

davidlandy:
Mr fruit loop

you have a reply ...
http://www.hostmybb.com/phpbb/viewtopic.php?t=1745&mforum=wwwnorthants4x4

...and a pm

lurch_917:
 well jess your a bit like me you do play a bit rough now dont you

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version