Vehicle & Technical > Suzuki

vitara lift advice needed

(1/1)

mr_disco:
hi all

i just bought a 2 1/2inch spring spacr lift for my vitara and i  started fitting my lift yesterday, well anyways.......   i fitted the front 2 and whn i put every thing bk on tidy i noticed my wheels are cambering in,, (sitting onaa tilt) have any 1 got any ideas how to sort this

i have looked it up and u can change the bolt in the front struts (shocks),, but they are £27 for 2 boltsand i need it b4 then as i gt a off road day on sunday,,

could a normal bolt just do it but a little skinner so i can adjust the strut or wount ithold the shock and have  play

generation-x:
dont no if youuse ebay but bits4vits sells camber bolts if your quick he will get them out today for delivery tomoz

hope this helps

simon

suzota:
turn the bottom bolt hole into a slot and you can adjust the camber a bit that way, its better if you can weld a washer over the slot once you have the camber angle right.

mr_disco:
well i fitted the full lift today,, well i had a better look at the camber today and i could adjust it slightly as i put a small nut an bolt init but no to small so it wount move,, the wheels are now about 90% ok,, aso i found out the anti roll bar was putting a little strain on it so i remocved that.,,,

do u think the shafts will be all ok with a 2 1/2 inch lift and 2 1/2 droopers aswell

Navigation

[0] Message Index