Vehicle & Technical > Series Land Rovers
Head Gasket Replacement.
hobbit:
He should have no probs then
Just remember its a cast iron head, so not very light
I was being idle whe I was refitting it being on my own I used an engine lift to line it up, stops dropping two round spherical anatomy parts when aligning head and not letting the gasket wander out of line ;)
landroverkeith:
--- Quote from: BadgersRover on July 03, 2008, 18:42:27 ---LOL cheers for that mate, but driving to the complete opposite end of the country is just not viable right now lol.
I have a mate of mine doing it tomorrow, he has his own garage and used to be a land rover main dealer mechanic.
Plus he is also only charging me £50 for doing it lmao
--- End quote ---
have ya got her done yet dan ? ill look for ya in msn boy
Yoshi:
No, it didnt need doing. It had just boiled over and runs fine now.
Just need a new rad cos all the veins were nackered which was why it boiled over.
baron von ledwidge:
Its a really easy job i htinki did it in about 3 hours with driving to source the gaskets, shouldnt be too much of an issue mate tho the ehads do weigh [!Expletive Deleted!] loads
TechnoTurkey:
I did mine in a weekend, but it was years ago and the first 'proper' job I did on a landy, very satisfying!
Navigation
[0] Message Index
[*] Previous page
Go to full version