Vehicle & Technical > Discovery

Gearbox problems?

<< < (2/2)

crazymac:

--- Quote from: MZ6666 on July 02, 2008, 20:01:56 ---Cheers, folks.
Crazymac, Is it a straight swop or are there any mods to do?

--- End quote ---

Mine was already done when I bought it, but I don't believe its difficult? I think its just down to using the same bellhousing? no doubt you could get a better answer on here.

lee celtic:
I hope your gonna visit ;)

oh and we're away until the 11th.

See you soon Bro... :D

andyb:

--- Quote from: MZ6666 on July 02, 2008, 20:01:56 ---Is it a straight swop or are there any mods to do?

--- End quote ---

Relatively straight swap. You will need to swap in the speedo housing and the hand brake housing from an LT77, or you could just swap over the transfer box if you get just the R380 main box. The speedo on the R380 has a different sender and different cable. The handbrake also has a different setup, so I thought it easier to swap in the LT77 related bits.

Altho the mouning are different the transfer box has the right holes for either setup. If you are getting a bare main box and just swapping in the transfer box off the LT77 then this is not going to be an issue. Otherwise just swap the mounting about.

HTH

Navigation

[0] Message Index

[*] Previous page