Vehicle & Technical > Discovery

TURBO BOOST GAUGE PLUMBING - UPDATE

<< < (2/2)

bambamjj:
Thanks Wizard, cant see phot's, not sure if problem my end.

Will check when i get home.

regards

wizard:
I have loaded the pix in my gallery under turbo pix.

Regards
wizard :twisted:

Chris Putt:
To give a true reading of boost that is a better measure you are better off measuring at the inlet manifold.

On my 200tdi, there was a plug in the inley manifold that we took out, tapped out he ran the pipe for the boost gauge from.


Chrid

bambamjj:
Any picture chris?

bambamjj:
well fitted it last night at the pump end, had  real trouble with hose not fitting, splitting etc.

When for a run, she was running at nearly 2 Bar,   :dance: EXCELLENT! but had to wind it in a lot,  :cry: so readings now are as follows


General around town, varies with engine speed
Foot to floor gets up to 1.1bar,
Motor way long climb goes up to 1.1 bar then settles to about .6 bar cruising.

Hope this is about right, not so much fun to drive since i had to wind it back tho.

Navigation

[0] Message Index

[*] Previous page