Vehicle & Technical > Discovery

can i get an off the shelf 4" body lift?

<< < (2/6) > >>

lee celtic:
we use these..

http://www.anixter.co.uk/AXECOM/UK.NSF/ProductsTechnology/SolutionsAnixterFastenersAboutUs

They supply every type of nut bolt and thread going...Though they are industrial supply so you may have to buy a box,But they are cheap..

You could also try http://www.custom-fasteners.co.uk/ Mainly bike stuff but they do sell hardened studs up tp 8" (you just put a nut on both ends)

windowlicker:
cheers for the info lads i never thought of threaded bar as i was unsure if the threaded part was in the body so i assume that its just a nut and bolt?

lee celtic:
Yep just a nut and bolt though I think the theaded bar might be a bit soft.

if you can get bolts long enough the thread won't matter. but the head of the bolts may have to drop through holes in the floor or cross member to go through the body mounts so check the head size as well...:D

clover:
Get yourself some proper bolts and locking nuts as there is a lot of stress put through those bolts. You would be amazed how much the body shell twists!

karlo:

--- Quote from: windowlicker on June 09, 2008, 21:20:24 ---cheers for the link i looked at them earlier but they are only 50mm and the bolts are also 50mm shorter than i need

--- End quote ---

Yes but it has bolt diameters on there  ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page