AuthorTopic: Noise??  (Read 579 times)

0 Members and 1 Guest are viewing this topic.

Offline R2D2

  • Posts: 156
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • "Old Tart" white, new "Jump-Jet" blue one 2xLPG
  • Referrals: 0
Noise??
« on: June 08, 2008, 13:05:39 »
Hi again

Want to make me rangie a bit louder, but stay sophisticated as well.  ;) ;)   1986 3.5 Efi

Has a stainless system on at the mo and I don't really want to cut back box off, so was thinking of a big bore system?

Any suggestions?
Rgds  David
:smiley:

Gosh, this water's deep!!! Only comes half-way up that duck.

Offline dod51e

  • Posts: 240
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Referrals: 0
Re: Noise??
« Reply #1 on: June 17, 2008, 23:32:56 »
You could try a SS stainless sports system (with headers).  I had this on my old 3.5.  Suitable loud under load but really not too bad at all under normal driving conditions.  It had centre and back box.

Offline R2D2

  • Posts: 156
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • "Old Tart" white, new "Jump-Jet" blue one 2xLPG
  • Referrals: 0
Re: Noise??
« Reply #2 on: July 10, 2008, 14:15:10 »
Hi again,

Thinking of removing the ss sytem from join so it's still usable, then shoving on a nice wide smithies from our local american car workshop then using some big bore flexi to take it over axle to a nice side exit. :cool:  :cool:

When funds permit of course  [-o<   :doh:
« Last Edit: July 22, 2008, 09:19:04 by R2D2 »
Rgds  David
:smiley:

Gosh, this water's deep!!! Only comes half-way up that duck.

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal