Vehicle & Technical > Series Land Rovers

MOT stuff

<< < (2/3) > >>

edy:
hi, cheers everyone. bassically there is a a bit by where the bulkhead connects to the outrigger but i have brought all the a posts and new parts for that and the footwells. the problem with the top is there is a few metal fabricators around but you have to take the motor to them. so i was thinking get it through its MOT so then i can legally drive it to the bloke and he will fabricate somthing for me to weld in place, you fell a bit of an idiot trying to describe it to people  :) it is bassically where the windscreen connects to the balkhead though, but is it possible to justtake the windscreen off, i have a full canvas so it is no trouble to do it? might have to get the angle grinder out to take the sharp edges off though.

cheers

Les Henson:
You can get bulkhead repair panels for the area you describe. If you are worried about the MOT, then use filler for now and then sort it out properly afterwards.


Les.

edy:
ye i could do that, good idea. no ive got the repair panels and they dont cover the inside, out side is fine but the inside has no sort of panel for it, its bassically the part that the window attacs to. ive got a pic of it, make explaining it easier


thanks for all the help. think taking it off will be easier.

Rich_P:
You can replace that corner piece with a panel as a temporary repair, but it does look quite bad.  Then again, a mate of mine just used a repair panel and cut out all the rot there so had a bit of a gap and used his 2A like that for a few years!

edy:
a repair panel for the inside? really, i have never seen one. im not overly bothered about the look that much

cheers :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page